tricks of the trade #2...

Following on from my previous post around this subject, this time I'm going to show you what I do with my ends of embroidery thread while I'm sewing a Softie. 

When I'm sewing, I often have a few different colours on the go, which rather then tying off, I'll thread through to the back in case I need that colour again.

But obviously, these thread are not going to be where I want them to be, when I come to use them again.  So how do I get from one place to another?  I simply use the needle to literally, snake the thread around the inside of the Softie.

Begin by waggling the thread to make the hole in the fabric slightly larger, then pull the thread hard in one direction to create a gap right next to it, feed the needle carefully though this same hole.  

Take the needle back out where you want it next to go, and gently pull on the thread.

Once the thread is pulled through completely the hole kind of magically disappears, it has now moved to the new position ready to continue the applique or repeat this process to move it further.

A simple process, but this is something I get asked a lot, so I hope that explains how I go about it when I'm sewing.

Something else I must mention is, hop on over to Cut Out & Keep which is a FAB resource for project tutorials, I am a Crafty Superstar this week, yay!  There is an interview and a project a day too.